1. Install a new valve guide seal.
NOTE: The intake spring retainer has a longer free length compared to the exhaust spring retainer.
2. Install the valve spring.
3. Install the valve spring retainer.
4. Using the valve spring compressor (special tool #9065C, Compressor, Valve Spring) (3) and the rocker arm adapter (special tool #9065-3, Adapter, Valve Spring Compressor) (1), compress the valve spring and install the valve spring retainer locks.
5. Remove the valve spring compressor (special tool #9065C, Compressor, Valve Spring) (3) and the rocker arm adapter (special tool #9065-3, Adapter, Valve Spring Compressor).
6. Release the air charge (1) in the cylinder.
CAUTION: Verify that the pushrods are fully seated into the lifters and the rocker arms. Recheck after rocker arm shaft has been torqued to specification.
7. Install the rocker arm shaft and push rods. Refer to ROCKER ARM, VALVE, INSTALLATION.
Courtesy of CHRYSLER GROUP, LLC
NOTE: Repeat torque sequence several times to ensure rocker shaft assembly is firmly seated.
8. Using the sequence shown in illustration, tighten the rocker arm shaft bolts to 22 N.m (16 ft. lbs.).
9. Remove the pushrod retainer (special tool #9070, Retainer, Push Rod) (1).
10. Position the cylinder head cover onto the cylinder head.
11. Using the sequence shown in illustration, tighten the cylinder head cover bolts to 8 N.m (6 ft. lbs.). Refer to COVER(S), CYLINDER HEAD, INSTALLATION.
12. Install the air cleaner housing (5) and clean air tube (1). Refer to BODY, AIR CLEANER, INSTALLATION.
13. Connect the negative battery cable.
14. Road test the vehicle.