1. Check the continuity across the lead (1) and brush (2) with an ohmmeter. 2. If it does not conduct, replace the yoke assembly. 3. Check the continuity across the brush (2) and yoke (3) with an ohmmeter. 4. If it conducts, replace the yoke assembly.
1. Check the continuity across the commutator and armature coil core with an ohmmeter. 2. If it conducts, replace the armature. 3. Check the continuity across the segments of the commutator with an ohmmeter. 4. If it does not conduct, replace the armature.
1. Check the continuity across the brush holder and the holder support with an ohmmeter. 2. If it conducts, replace the brush holder.
1. If the contact face of the brush is dirty or dusty, clean it with emery paper. 2. Measure the brush length (A) with vernier calipers. 3. If the length is less than the allowable limit, replace the yoke assembly and brush holder.
1. Check the contact face of the commutator for wear, and grind the commutator with emery paper if it is slightly worn. 2. Measure the commutator O.D. with an outside micrometer at several points. 3. If the minimum O.D. is less than the allowable limit, replace the armature. 4. If… Read More »
1. Inspect the pinion for wear or damage. 2. If there is any defect, replace the overrunning clutch assembly. 3. Check that the pinion turns freely and smoothly in the overrunning direction and does not slip in the cranking direction. 4. If the pinion slips or does not rotate in… Read More »
1. Remove the end cover (1). 2. Take out the plunger (2).
1. Remove the drive end frame (1) mounting screws. 2. Take out the overrunning clutch (2), ball (3), spring (4), gears (5), rollers (6) and retainer (7). (When reassembling) • Apply grease to the gear teeth of the gears (5) and overrunning clutch (2), and ball (3).
1. Disconnect the connecting lead (9) from the magnet switch (8). 2. Remove the screws (6), and then separate the end frame (4), yoke (2) and armature (1). 3. Remove the two screws (5), and then take out the brush holder (3) from the end frame (4). (When reassembling) • Apply grease to the spline… Read More »
1) Lead Terminal Voltage 1. Disconnect the lead from the coolant temperature sensor after turning the main switch off. 2. Turn the main switch on and measure the voltage with a voltmeter across the lead terminal and the chassis. If the voltage differs from the battery voltage, the wiring harness, fuse or coolant temperature gauge… Read More »