1. Check cylinder block deck surface for warpage at cylinder head gasket surface. Resurface cylinder block if warpage exceeds specification. See CYLINDER BLOCK table under ENGINE SPECIFICATIONS. DO NOT remove more than .010″ (.25 mm) of material from cylinder block if resurfacing cylinder block. 2. Measure cylinder bore diameter… Read More »
The Camshaft Removal and Installation Adapter, 303-1517 is used to remove and install the camshaft.
The Compression Adapter Tester, 303- 1515 is used to adapt the compression tester to the 6.7L diesel engine.
The Valve Spring Compressor, 303- 1516 is used to compress the valve springs to remove the valve keepers.
The EGR Pressure Tester, 303-1511 is used to check for coolant leaks. EGR Cooler Secondary Coolant Passage Tester
The EGR Pressure Tester, 303-1511 is used to check for coolant leaks. EGR Cooler Primary Coolant Passage Tester
The Engine Removal Bracket, 303- 1518 is used to remove and install the 6.7L diesel engine.
The Fuel Injector Remover, 310-230 is used to remove the fuel injectors from the 6.7L diesel engine.
The Rear Crank Seal Installer, 303-1514 is used to install the rear crankshaft seal.
The Rear Crank Seal Remover, 303-1513 is used to remove the rear crankshaft seal.