1. Using (special tool #10387, Installer, Vibration Damper), install the threaded rod (1) onto the crankshaft (2).
2. Tighten the threaded rod (4) until it is seated to the face (3) of the crankshaft.
3. Position the damper (2) on the crankshaft.
4. Install the press washer, bearing, washer, and the press nut onto the threaded rod.
5. Using Damper Installer (1) and a deep well socket, press the damper onto the crankshaft till seated.
6. Install the vibration damper bolt.
7. Position the (special tool #10386, Holder, Vibration Damper) (2), onto the vibration pulley (3).
8. Tighten the bolt to 250 N.m (184 ft. lbs.).
9. Install the accessory drive belt. Refer to BELT, SERPENTINE, INSTALLATION .
10. Install the cooling fan. Refer to FAN, COOLING, INSTALLATION .
11. Install the oil cooler hose (4) and clamp (3).
12. Install the upper radiator hose (2) and clamp (1).
13. Refill the cooling system. Refer to STANDARD PROCEDURE .
14. Connect the negative battery cable (1).