NOTE:
Left side shown in illustration, right side similar.
1. If removed, position the engine mount to engine block mounting brackets, install the retaining bolts and tighten to 61 N.m (45 ft. lbs.).
NOTE: Left side shown in illustration, right side similar.
2. Position the engine mounts (2), Install the retainers (1) and tighten to 61 N.m (45 ft. lbs.).
3. Position the generator support bracket (3) to the engine mount, install the retaining nut (1) and tighten finger tight.
4. Position the generator support bracket (3) to the generator, install the retaining bolt (2) and tighten to 65 N.m (48 ft. lbs.).
5. Tighten the generator support bracket (3) to engine mount retaining nut (1) to 28 N.m (21 ft. lbs.).
6. Lower the vehicle.
7. Lower the Engine Support Fixture (special tool #8534B, Fixture, Driveline Support) (3) until the engine mounts are seated in the engine cradle.
8. Remove the Engine Lift Fixture (special tool #8984B, Fixture, Engine Lifting) (1), Engine Lift Adapter (special tool #8984-UPD, Adapter, Engine Lift) (2) and the Engine Support Fixture (special tool #8534B, Fixture, Driveline Support) (3).
9. Install the VVCS (3). Refer to SOLENOID, VARIABLE VALVE TIMING (VVTS), EXHAUST, INSTALLATION.
10. Raise and support the vehicle.
NOTE:
Left side shown in illustration, right side similar.
11. Install both left/right engine mount lower retaining bolts (2) and tighten to 61 N.m (45 ft. lbs.).
12. Position both left/right engine mount heat shields (4), install the retaining nuts (3) and tighten to 27 N.m (20 ft. lbs.).
13. Position the belly pan and install the belly pan retainers (1).
14. Lower the vehicle.
15. Position the engine oil dipstick tube, install the retaining nut at the right exhaust manifold.
16. Install the intake manifold. Refer to MANIFOLD, INTAKE, INSTALLATION.
17. Connect the negative battery cable (1).