Begin with a thorough visual inspection of the engine, particularly at the area of the suspected leak. If
an oil leak source is not readily identifiable, the following steps should be followed:
1. Do not clean or degrease the engine at this time because some solvents may cause rubber to
swell thus temporarily stopping the leak.
2. Add an oil soluble dye (use as recommended by manufacturer). Start the engine and let idle for
approximately 15 minutes. Check the oil dipstick to make sure the dye is thoroughly mixed as
indicated with a bright yellow color under a black light.
3. Using a black light, inspect the entire engine for fluorescent dye, particularly at the suspected
area of oil leak. If the oil leak is found and identified, repair per Service Information procedures.
4. If dye is not observed, drive the vehicle at various speeds for approximately 24 km (15 miles),
and repeat inspection.
If the oil leak source is not positively identified at this time, proceed with the AIR LEAK DETECTION TEST METHOD.