NOTE: Apply Moparยฎ Thread Sealant with PTFE to the sensor threads before installing into the engine block.
1. Install the oil pressure sensor (1).
2. Connect the oil pressure sensor electrical connector (1).
3. Position the generator and install the upper mounting bolt finger tight.
4. Raise and support the vehicle.
5. Install the lower mounting bolts (1) and tighten to 55 N.m (41 ft. lbs).
6. Position the lower splash shield and install the retainers (1).
7. Lower the vehicle
8. Tighten the upper generator mounting bolt to 55 N.m (41 ft. lbs).
CAUTION: When installing a serpentine accessory drive belt, the belt MUST be routed correctly. The water pump may be rotating in the wrong direction if the belt is installed incorrectly, causing the engine to overheat.
9. Install the accessory drive belt. Refer to BELT, SERPENTINE, INSTALLATION .
10. Connect the negative battery cable.