Prior to installation, check the crossheads for damage.
Refer to Procedure 002-001 in Section 2.
Install the crossheads in their original location and position.
Lubricate the push rod sockets with clean 15W-40 lubricating engine oil.
Install the rocker lever assemblies and pedestals in their original position.
Install the pedestal mounting capscrews.
Tighten the pedestal mounting capscrews.
Torque Value: 36 Nโขm [ 27 ft-lb ]
Rotate the adjusting screws until the adjusting screw contacts the socket of the push rod. This will make sure the push rod stays in contact with the tappet and adjusting screw when the engine is rotated to set valve lash. If not completed, the push rods may be bent or damaged.
