All Applications
Use a hoist or lifting fixture to support the rear of the engine.
Rear Gear Train
NOTE: When removing the rear engine mount fasteners, keep track of the location of any shims or spacers used.
Remove the engine mount fasteners.
Remove the rear support capscrews and bracket.
Loosen the flywheel housing cap screws, but do not remove.
Use a rubber hammer to loosen the flywheel housing so that the seal is broken between the flywheel housing and
rear gear housing.
While supporting the flywheel housing, remove the mounting cap screws and the flywheel housing.
Note the location of the flywheel housing cap screws as removed. Some of the cap screws are different length/size
fasteners and must be installed in the same location as removed.
Front Gear Train
While supporting the flywheel housing, remove the mounting cap screws.
While supporting the flywheel housing, use a rubber hammer to loosen the flywheel housing.
Remove the flywheel housing.
NOTE: Some engines can have an additional rectangular seal between:
โข The flywheel housing and the rear seal carrier
โข The flywheel housing and camshaft journal bore of the block.
NOTE: When removing the flywheel housing, note the location of any locating dowel rings.
