The fuel filter is easily removed and installed with the use of a screwdriver. To prevent fuel spillage โ drain fuel from the filter by opening both the air bleed and water drain valve allowing fuel to drain out โ into an appropriate container.
To remove the filter:
1. Remove fuel tank cap. This releases any pressure or vacuum in the tank.
2. Disengage both bail wires with a screwdriver.
3. Remove the filter.
4. Clean any dirt off the fuel port sealing surface of the filter adapter and the new filter.
5. Install the new filter โ snap into position with bail wires.
6. Close the water drain valve โ and open the air bleed. Connect a 1/8″ I.D. hose to the air bleed port and place
the other end into a suitable container.
7. Disconnect fuel injection pump shut off solenoid wire. (See illustration).
8. Crank engine for 10-15 seconds and then wait one minute for the starter motor to cool. Repeat until clear fuel is observed coming from the air bleed.
9. Close the air bleed, reconnect the injection pump solenoid wire and replace fuel tank cap.
10. Start engine and allow it to idle for 5 minutes.
11. Check fuel filter for leaks.
