If removed, install the priming fuel filter head bracket and mounting hardware. Tighten the mounting hardware. Torque Value: 24 N•m [ 212 in-lb ] Install the fuel filter head bracket. Install the fuel filter head bracket mounting capscrews. Torque Value: 24 N•m [ 212 in-lb ] Install the fuel line brace. Install the fuel line… Read More »
Remove the fuel line brace mounting fastener. Remove the fuel line mounting brace. Remove the fuel filter head bracket mounting hardware and bracket. Clean the removed components with solvent. Dry with compressed air. Inspect the filter head bracket, fuel line brace, and clips for cracks. Replace the component if any damage is found.
Front Gear Train Install the fuel filter head. Install the fuel filter head mounting capscrews. Torque Value: 24 N•m [ 212 in-lb ] Rear Gear Train NOTE: The fuel filter head and fuel filter head bracket can be one piece. The fuel filter head is marked with IN and OUT arrows to indicate flow. Be… Read More »
Front Gear Train Lubricate the quick-disconnect a-rings before installing into the filter head. Install the fitting into the filter head. Torque Value: 24 N•m [ 212 in-lb ] Rear Gear Train Lubricate the quick-disconnect a-rings before installing into the filter head. Install the quick-disconnect fittings. Torque Value: 24 N•m [ 212 in-lb ]
For front gear train engines, verify the screened quick- connect fitting on the outlet side of the fuel filter housing is free of debris. If debris is found, rinse the screen with an evaporative cleaner. Replace the fitting if the debris can not be removed. Inspect the fuel filter head for cracks, passage blockage, and… Read More »
Front Gear Train Remove the screened quick-connect fitting. Rear Gear Train Remove the quick-connect fittings.
Front Gear Train Remove the fuel filter head mounting capscrews. Remove the fuel filter head. Rear Gear Train NOTE: The fuel filter head and fuel filter head bracket can be one piece. The fuel filter head is marked with IN and OUT arrows to indicate flow. Be sure to note the orientation of the fuel… Read More »
After filter change or running the vehicle tank dry: (Make sure there is fuel in the vehicle fuel tank) NOTE: It is not necessary to vent air from the high pressure fuel system before starting the engine. Cranking the engine will prime the fuel system. NOTE: To prevent damage to the hand pump priming seals,… Read More »
NOTE: If available, pre-fill new filters, both pressure side and suction side, with clean fuel prior to assembly using the clean side block-off plug packed with the filter. Do not pour fuel directly in the center of the filter, since this will allow unfiltered fuel to enter the system and can cause damage to fuel… Read More »
NOTE: The following steps can be used for replacing the pressure side and suction side fuel filter. Use fuel filter wrench, Part Number 3398231. Loosen and remove the fuel filter. Make sure the o-ring does not stick to the fuel filter head. Remove the o-ring with an o-ring pick, if necessary.