• It is possible to see service data and actuator tests simultaneously.
• It is possible to see service data and actuator tests simultaneously.
• Freeze frame data is the value of service data at the generation of a diagnosis code. • Multiple freeze frame data related to the generated diagnosis code can be accessed on Multi-Use Tester. • For diagnostic criteria, see the table of service data.
3.1 Diagnosis code list • Diagnosis codes shown by the Multi-Use Tester and those indicated by flashing of the warning lamp are different. • Diagnosis codes for the battery electronic control unit (except minor faults (codes with or)) are sent to the meter cluster via the motor electronic control unit. These codes are checked with… Read More »
• Before measuring voltage, check the battery for charged condition and specific gravity. If system inspection is performed with the battery uncharged or reduced in specific gravity, accurate measurements cannot be achieved. • Before disconnecting battery cables, harnesses and connectors, set the starter switch to LOCK or OFF, then allow at least 20 seconds. •… Read More »
• Perform the inspection in accordance with the following flowchart.
• These inspections aid troubleshooting by enabling you to check whether electronic control unit signals are being correctly transmitted via the vehicle harness and connectors. The white-on-black numbers ( 01 , 02 , and so on) correspond to the similarly printed reference numbers in section “3. Inspections Based on Diagnosis Codes”. 7.1 Electronic control unit… Read More »
• It is possible to see service data and actuator tests simultaneously.
• It is possible to see service data and actuator tests simultaneously.