The hydraulic pump above the rear PTO shaft supplies hydraulic pressure to the PTO solenoid valve. The solenoid valve has a pressure relief valve that opens at a minimum pressure of 2068 kPa (300 psi). The PTO valve contains a divider valve that sends 50% of the oil to the loader selective control valve (SCV),… Read More »
The purpose of this procedure is to select correct shims to set the cone point and backlash. If any of the following components in the transmission is replaced, the procedure is performed: 1. Bevel Pinion 2. Bevel Ring Gear 3. Main Case 4. Front Cover 5. Side Cover or Rear Axle Housing 6. Brake Quill… Read More »
Adjust the forward and reverse motion control pedal stops to assure full travel of the hydrostatic transmission control without overtravel loads on control linkage. [1] – Park machine safely. [2] – Raise rear of machine and safely support frame. [3] – Remove center closeout panel for access to transmission motion control eccentric adjuster. (See Remove… Read More »
The differential lock linkage must be properly adjusted in order to fully engage the differential lock within the range of movement of the operator control. [1] – Park machine safely. [2] – Block front wheels securely, disengage MFWD and release park brake lock. [3] – Raise rear of machine and support on jack stands. Remove… Read More »
Make adjustment to the hydrostatic pump control neutral position eccentric if creep is evident with the machine on a level surface with the engine running, brakes released, and no movement of the transmission control pedals. →NOTE: If creep is intermittent, inspect the transmission control linkage for binding or damage. Repair linkage before making adjustment to… Read More »
MFWD Lever Hard to Engage Refer to Section 50, Group 35. MFWD Lever Will Not Stay ON Refer to Section 50, Group 35.