1. To slow charge the battery, connect the battery positive terminal to the charger positive terminal and the negative to the negative, then recharge in the standard fashion. 2. A boost charge is only for emergencies. It will partially charge the battery at a high rate and in a short time. When using… Read More »
1. Check the battery condition by reading the indicator (2). IMPORTANT • The factory installed battery is of non-refillable type. If the indicator turns white, do not charge the battery but replace it with new one.
1. Turn the main switch on, and turn on the head light. 2. Measure the voltage across the battery’s positive terminal post and the cable terminal, the voltage across the battery’s negative terminal post and the chassis. 3. If the measurement exceeds the factory specification, clean the battery… Read More »
1. Stop the engine and turn the main switch off. 2. Connect the COM (−) lead of the voltmeter to the battery’s negative terminal post and the (+) lead to the positive terminal post, and measure the battery voltage. 3. If the battery voltage is less than the factory specification, check the… Read More »
Tightening torques of screws, bolts and nuts on the table below are especially specified.
The seat switch (2) is mounted on the seat rail (4) under the operator’s seat (1). It serves as a safety switch of OPC system. It detects the position of the operator’s seat. When no body sits on the operator’s seat (1), the battery current does not flow from the key switch “AC” terminal, through… Read More »
• PTO gear shift lever: “OFF” • HST pedal: “Neutral” • Seat: “When operator does not sit on the seat” As shown in the above electric circuit, the battery voltage flows to the key stop solenoid. And the pulling and the holding coil in the key stop solenoid is electrical magnet. The spring in the… Read More »
• PTO gear shift lever: “OFF” • HST pedal: “Neutral” • Seat: “When operator does not sit on the seat” As shown in the above electric circuit, the battery voltage flows to the key stop solenoid. And the pulling and the holding coil in the key stop solenoid is electrical magnet. The spring in the… Read More »