Apply a bead of Loctite 277 or equivalent to the outside diameter of the seal.
Leave the plastic pilot installation tool in the lubricating oil seal.
Position the seal on the service tool, Part No. 3824499, with the lubricating oil seal dust lip facing outward.
NOTE: Properly support the front cover lubricating oil seal flange to prevent damage to the lubricating oil seal and front cover.
Press the lubricating oil seal into the front cover from the back side of the cover toward the front side of the cover.
Press the lubricating oil seal until the service tool bottoms against the front cover.
Apply a thin bead of Three BondTM to the cover side of the front cover gasket only.
NOTE: Do not remove the plastic seal pilot tool from the lubricating oil seal at this time. Use the plastic seal pilot tool
to guide the seal on the crankshaft.
Install the gasket and front cover on the engine.
Tighten the front cover mounting capscrews.
Remove the plastic pilot tool from the crankshaft.
Torque Value: 24 N*m [18 ft-lb]
Install the crankshaft pulley. Do not tighten the capscrews to the correct torque value at this time.
Install the drive belt.
Tighten the crankshaft pulley capscrews.
Torque Value: 125 N*m [92 ft-lb]
