Install a new seal in the gear cover. Refer to Procedure
Apply a thin bead of Three-BondTM to the cover side of the front cover gasket only.
NOTE: Do not remove the plastic seal pilot tool from the lubricating oil seal at this time. Use the plastic seal pilot tool
to guide the seal on the crankshaft.
Install the gasket and front cover on the engine.
10 mm
Tighten front cover capscrews.
Remove the plastic pilot tool from the crankshaft.
Torque Value: 24 N*m [18 ft-lb]
15 mm
Install the crankshaft pulley. Do not tighten the capscrews to the correct torque value at this time.
Install the drive belt.
Tighten crankshaft pulley capscrews.
Torque Value: 125 Nยซm [92 ft-lb]
