Insert the plastic trough the full length of the cam bore.
Lower the tappet installation tool down the push tube hole, through the tappet bore, and into the trough.
Feed the installation tool through the cam bores by careยญfully pulling the plastic trough/installation tool out the
front. The barrier at the rear of the trough will pull the tool out most of the time.
Lubricate the tappets with LubriplateTM 105.
Insert the installation tool into the tappet.
NOTE: To aid in removing the installation tool after the tappet is installed, work the tool in and out of the tappet several times before installing the tappets.
Slide the trough into the cam bore.
Pull the tool/tappet through the cam bore and up into the tappet bore.
If difficulty is experienced in getting the tappet to make the bend from the trough up to the tappet bore, pull the trough
out enough to allow the tappet to drop down and alignitself, then pull the tappet up into the bore.
After the tappet has been pulled up into position, slide the trough back into the cam bore and rotate it 1/2 turn. This
will position the round side of the trough up, which will hold the tappet in place.
Remove the installation tool from the tappet.
Install a wooden dowel into the top of the tappet. Wrap rubber bands around the wooden dowels to secure the tappets.
Repeat this process until all tappets have been installed.
