NOTE: Prior to removal, note position length of the control rod from the boost capsule housing and orientation of the
boost capsule hose connector in relation to the mounting bracket.
Disconnect the boost capsule actuator rod end from the turbocharger wastegate lever. This can be accomplished
by applying regulated air pressure to the boost capsule in a sufficient amount to activate control rod movement.
Disconnect the control rod from the turbocharger waste gate lever pin.
Caution: Be careful not to bend the control lever.
NOTE: If the boost capsule diaphragm material is ruptured and will not hold air pressure other than by hand, manually
pull the control rod outward in order to overcome boost capsule spring tension for removal of the control rod from the
turbochager wastegate lever pin.
Loosen the boost capsule mounting capscrews, disconnect the air supply hose and remove assembly from the
mounting bracket.
Remove the adjusting link end from the boost capsule actuator.
Fit the new boost capsule actuator assembly to the actuator mounting bracket and install the mounting cap screws.
Torque Value: 4.5 N®m [40 in-lb]
