Removal
• Remove the electrical wiring.
• Remove the fuel drain line.
• Remove the throttle/shutoff linkage.
• Remove the fuel injection pump top cover.
• Disassemble the fuel injection pump top cover.
5/16 Inch
Install new insulating tubes onto the terminals on the terminal studs of the new solenoid.
Install the valve into the cover.
Torque Value: 14 N»m [12 in- lb]
Installation
5/16 inch
Install the cover and gasket onto the fuel injection pump.
With the tool installed as shown, place the cover in position on the pump housing. Twist the tool to release it and
slide it out from between the cover and the housing.
NOTE: Extreme care must be taken in assembling the cover to a fuel injection pump to make sure the shutoff arm is in
proper contact with the linkage hook tab.
In the event that the service tool is not available, the governor cover should be installed as follows:
Move the shut off lever to the stop position.
Install the cover to pump at a downward angle from the drive shaft end of the fuel injection pump, then slide the
cover horizontally into position.
Torque Value: 4.6 N®m [41 in-lb[
