[1] –
→NOTE:
Make sure that all O-rings are in place when installing the valve body and
hydraulic pipes.
Install O-rings at transmission case PTO passages.
[2] – Install PTO valve and secure with two bolts (A).
[3] – Make sure that O-rings are in place at valve fittings.
[4] – Install hydraulic pipe nuts (B) to valve fittings. Tighten to specification.
[5] – Install hydraulic pipe nut (C) to valve elbow fitting. Tighten to specification.
[6] – Install wire harness connector (D) to solenoid.
[7] – Install rear wheel. (See “Remove and Install Rear Wheels” in Section 80, Group 10.)