[1] – Park machine safely.
[2] – Remove four fasteners (A) securing steering pedestal cowl. Remove cowl.
[3] – Rotate height of cut adjuster control (B) to lowest (install) position. Remove control knob.
[4] – Remove center closeout panel (C). (See Remove and Install Center Closeout Panel in Group 90, Section 15.)
[5] – Remove ten hex shoulder bolts (D) and washers securing foot rest. Remove foot rest.
[6] – Remove two M10 hex nuts and bolts (E) from left side frame.
[7] – Install M8x15 carriage bolt (F) to lift cylinder bracket and secure with M8 hex nut.
[8] – Install lift cylinder bracket to frame with two M10x35 carriage bolts and loosely secure with M10 hex nuts (G).
[9] – Remove hex nut and carriage bolt (H) securing fuel hose retainer. Move fuel hoses aside.
[10] – Install lift cylinder (I) to frame bracket with inlet fitting at bottom.
[11] – Install M12x100 drilled pin (J) through footrest bracket, frame bracket, and cylinder.
Secure with locking pin.
[12] – Secure fuel hose retainer to footrest bracket with carriage bolt and hex nut.
[13] – Secure cylinder rod to rockshaft bracket with M12x60 drilled pin (K) and locking pin.
[14] – Tighten hex nuts securing lift cylinder bracket to frame.
[15] – Reinstall foot rest, steering pedestal cowl, and center closeout panel.