Remove the right side controls console and fender for access to the SCV and right side of the transmission.
[1] – Park machine safely.
[2] – Remove rear wheel weight(s) (if installed).
[3] – Remove right wheel. (See procedure in section 80-10.)
[4] – Remove two hex shoulder bolts (A) and flat washers securing fender to bottom bracket.
[5] – From under fender, remove two hex nuts (B) securing handle to fender bracket.
[6] – Remove wire harness connector (C) from work light (if installed).
[7] – Move rockshaft control lever (D) to middle of control slot.
[8] – Lift controls console from fender, passing rockshaft lever knob through slot.
[9] – Remove wire harness connector (E) from power port.
[10] – Set controls console aside.
[11] – Remove knob (F) from SCV control lock.
[12] – Remove five hex flange shoulder bolts (G) and flat washers securing foot rest.
[13] – Lift fender, passing rockshaft lever and SCV lock shaft through fender slots.
[14] – Raise outer edge of foot rest (H), releasing base of fender. Remove fender.