John Deere – 1023E, 1025R and 1026R – Reverse Pedal Switch Test

[1] –

[2] – Remove center closeout panel. (See Remove and Install Center Closeout Panel in Section 90, Group 15.)

[3] – Disconnect wiring harness from reverse pedal switch.

[4] – Use hydro pedals to move bell crank away from reverse pedal switch plunger.

[5] – Use ohmmeter to check continuity across switch terminals.
a. If continuity is not present between terminals listed for each switch position, replace switch.
b. If continuity exists between terminals not listed for each switch position, replace switch.

[6] – Connect wiring harness to reverse pedal switch.

[7] – Install center closeout panel. (See Remove and Install Center Closeout Panel in Section 90, Group 15.)