Adjust park brake engagement after the service brake adjustment procedure has been completed. (See Adjust Brakes in this Group.)
[1] – Park machine safely.
[2] – Adjust service brake linkage. (See Adjust Brakes in this Group.)
[3] – Place park brake handle in fully lowered position. Adjust jam nuts (A) on brake cable (B) so that intermediate bell crank (C) is rotated as far forward at the top as it will go.
[4] – Be certain that there is no slack in brake cable and tighten jam nuts.
[5] – Loosen nut (D), and adjust the brake rod yoke (E) at the intermediate bell crank (C) so that there is no free play. Tighten nut (D).
[6] – Loosen two bolts (F), and adjust the park brake switch (G) position so that it is not engaged when the park brake handle is in the fully lowered position and so that it engages within 2-4 clicks of raising park brake handle.
[7] – Check park brake engagement. Verify the engine stalls with the transmission in high range when the park brake handle is in the fully engaged (raised) position.