KUBOTA – L2501 – TRANSMISSION – DISASSEMBLING AND ASSEMBLING – Shaft Case, Input Shaft and Gear

1. Remove the shaft case mounting screws.
2. Screw down the two M6 screws into the shaft case (1).
3. Take out the shaft case (1) with the input shaft assembly.
4. Separate the input shaft assembly with shaft case (1).
5. Remove the external cir-clip (2).
6. Remove the bearings (3), (5) with a bearing puller and 28T gear (4).
(When reassembling)
• Install the shaft case (1) the new gasket (8) in the place.
• Install the oil seal (7) as shown in the figure, noting its direction.
• Apply grease to the oil seal (7).