KUBOTA – L2501 – BRAKES – DISASSEMBLING AND ASSEMBLING – ROPS and Rear Wheel

1. Place the disassembling stand under the transmission case.
2. Remove the ROPS upper frame (1).
3. Remove the ROPS lower frame (2).
4. Loosen and remove the rear wheel mounting screws and nuts.
5. Remove the rear wheel (4).
(When reassembling)
• After tighten the ROPS fulcrum screw (3) and nut, install the cotter pin (6) as shown in the figure.
• Tighten the ROPS fulcrum screw (3) and nut so that the ROPS upper frame (1) does not fall down when the ROPS       upper frame (1) positioned at horizontal.
NOTE
• Do not firmly tighten all upper frame mounting screws until most components are attached.