1. Remove the suction pipe (1).
2. Remove the brake rod (2).
3. Separate the brake case (4), tapping the brake cam lever (3).
(When reassembling)
• Apply grease to the brake ball seats. (Do not grease excessively.)
• Apply liquid gasket (Three Bond 1206C or equivalent) to joint face of the brake case and transmission case, after eliminating the water, oil and stuck liquid gasket.
• Before installing the brake case to the transmission case, install the cam plate around the four protrusions on the differential bearing case.
• Apply liquid lock (Three Bond 1324 or equivalent) to the stud bolts.
• Be sure to check there are 6 balls one side.
NOTE
• Take care not to damage the O-rings (7).
• If the O-rings (7) are damaged, change them.
