KUBOTA – L2501 – FRONT AXLE – SERVICING – Clearance between Front Axle Case Bosses and Bracket Bushings

1. Measure the front axle case bosses O.D. with an outside micrometer.
2. Measure the bracket bushing I.D. with an inside micrometer and calculate the clearance.
3. If the clearance exceeds the allowable limit, replace the bracket bushing.
4. If the clearance still exceeds the allowable limit, replace the front axle case.

 Press-fitting Bushing
• When press-fitting a new bushing, observe the dimension described in the figure.

• Be sure to set the hole of bushing to the hole of front axle case boss.
NOTE
• After replacing the bushing, be sure to adjust the front axle rocking force. (See page 6-S6.)