KUBOTA – L2501 – STEERING – DISASSEMBLING AND ASSEMBLING – Bumper and Tie-rods

1. Place the disassembling stand under the transmission case.
2. Remove the bumper.
3. Remove the tie-rods with the tie-rod end lifter.
In this case, take special case not to damage the tie-rod end nut (slotted nut). (It is preferable to replace it with an      unrequired nut.).
4. Reinstall the bumper.

IMPORTANT
• After tightening the tie-rod end nut to the specified torque, install a cotter pin as shown in the figure left.