1. Remove the side cover (1).
2. Remove the steering joint shaft (5).
3. Disconnect the suction hose (3).
4. Disconnect the return hose (8).
5. Remove the delivery pipe (6), (7).
6. Remove the hydraulic pump (2).
(When reassembling)
• Lift the joint shaft (5) so that there should be a clearance (A) of more than 5 mm (0.2 in.) between the joint shaft (5) and flywheel housing.
Then fit the support (4) in position.
• Be sure to insert the screw into cut-out of joint shaft (5).
• Apply grease to spline part of joint shaft (5).
• Apply transmission fluid to the O-ring and take care not to damage it.
• Wind seal tape to the joint of return hose (8).
