1. Disconnect the negative battery cable (1).
2. Remove the engine covers (1).
3. Disconnect the ignition coil electrical connectors (1).
4. Position the electrical harness (2) aside.
5. Remove the ignition coil retaining bolts (3).
6. Remove the ignition coils (1).
7. Using the sequence shown in illustration, remove the cylinder head cover retaining bolts.
8. Remove the cylinder head cover (1).
9. Clean the sealing surface of the cylinder head (2).
NOTE: The cylinder head cover gasket may be used again, provided no cuts, tears, or deformation have occurred.