1. Clean the cylinder head cover (1) and the sealing surface of the cylinder head (2). Inspect and
replace gasket if necessary.
2. Install the cylinder head cover and hand start all fasteners.
3. Using the sequence shown in illustration, tighten the cylinder head cover bolts to 8 N.m (70 lbs in.).
4. Before installing the ignition coils, apply dielectric grease to the inside of the spark plug boots (1).
5. Install the ignition coils.
6. Tighten the ignition coil retaining bolts (3) to 7 N.m (62 in. lbs.).
7. Position the electrical harness (2).
8. Connect the ignition coil electrical connectors (1).
9. Install the engine covers (1).
10. Connect the negative battery cable.