1. Disconnect the negative battery cable (1).
2. Drain the cooling system. Refer to STANDARD PROCEDURE.
3. Remove the upper radiator hose clamp (1) and remove the upper radiator hose (2).
4. Remove the oil cooler hose clamp (3) and remove oil cooler hose (4).
5. Remove the accessory drive belt. Refer to BELT, SERPENTINE, REMOVAL.
NOTE:
When installing the puller tool, ensure the bolts are fully threaded through the entire crankshaft damper.
6. Remove the crankshaft damper retaining bolt.
7. Install the puller tool (2) making sure the bolts are fully threaded through the entire crankshaft damper.
8. Remove the crankshaft damper (1).
9. Using Seal Remover (special tool #9071, Remover, Seal) (1), remove the crankshaft front seal (2).