CAUTION: The front crankshaft seal must be installed dry. Do not apply lubricant to sealing lip or to outer edge.
1. Install the threaded rod (1) from the (special tool #10387, Installer, Vibration Damper) into the crankshaft (2) till seated.
2. Using Seal Installer (special tool #9072, Installer, Seal) and (special tool #10387, Installer,
Vibration Damper) (2), install the crankshaft front oil seal.
3. Position the damper (2) on the crankshaft.
4. Install the press washer, bearing, washer, and the press nut onto the threaded rod.
5. Using Damper Installer (1) and a deep well socket, press the damper onto the crankshaft till seated.
6. Install the vibration damper bolt.
7. Position the (special tool #10386, Holder, Vibration Damper) (2), onto the vibration pulley (3).
8. Tighten the bolt to 250 N.m (184 ft. lbs.).
9. Install the accessory drive belt. Refer to BELT, SERPENTINE, INSTALLATION.
10. Install the upper radiator hose (2) and clamp (1).
11. Install the oil cooler hose (4) and clamp (3).
12. Install the cooling fan. Refer to FAN, COOLING, INSTALLATION.
13. Refill the cooling system. Refer to STANDARD PROCEDURE.
14. Connect the negative battery cable (1).