1. Rotate the crankshaft to bring the number 1 cylinder at the top dead center of the compression stroke. The number 1 cylinder is the front cylinder on the right bank. The mark on the crankshaft balancer should be aligned with the mark… Read More »
1. Install the valve bridge. 2. Install the valve bridge pins. 3. Install the pushrods.
1. Install the exhaust manifold gasket. 2. Install the exhaust manifold. 3. Install the exhaust manifold bolts and nuts. Tighten: Tighten the exhaust manifold bolts and nuts to 57 N.m (42 lb ft) in the proper sequence. Tighten: Tighten the center exhaust manifold bolts and nuts an additional pass to 57 N.m (42 lb it)… Read More »
1. Install the exhaust manifold gasket. 2. Install the exhaust manifold. 3. Install the exhaust manifold bolts and nuts. Tighten: Tighten the exhaust manifold bolts and nuts to 57 N.m (42 lb ft) in the proper sequence. Tighten: Tighten the center exhaust manifold bolts and nuts an additional pass to 57 N.m (42 lb it)… Read More »
1. The markings on the gasket are as follows: • Grade A (1) • Grade B (2) • Grade C (3) • Block over-bored 0 .0 1 0 -0 .0 30 in (0.254 -0 .7 6 2 mm) (4) • Block over-bored 0 .0 1 0 -0 .0 30 in (0.254 -0 .7 6 2… Read More »
The markings on the gasket are as follows: • Grade A (1) • Grade B (2) • Grade C (3) • B lock over-bored 0 .0 1 0 -0 .0 30 in (0.254 -0 .7 6 2 mm) (4) • B lock over-bored 0 .0 1 0 -0 .0 30 in (0.254 -0 .7 6… Read More »
1. If a reciprocating component (crankshaft, connecting rod, piston, or bearings) has not been replaced, install the same grade head gasket that was removed. 2.The markings on the gasket are as follows: • Grade A (1) • Grade B (2) • Grade C (3) • Block over-bored 0 .0 1 0… Read More »
1. Install the valve lifter. 2. Install the valve lifter guides. 3. Install the valve lifter guide hold down bracket. NOTE: Refer to Fastener Notice. 4. Install the valve lifter guide hold down bracket bolt. Tighten: Tighten the valve lifter guide hold down bracket bolt to 11 N.m (97 lb in).
1. Lubricate the O-ring on the fuel injection pump adapter with engine oil. 2. Use a suitable tool to unload the spring tension from the two piece cam gear. Apply pressure towards the right side of the engine while installing the fuel injection pump. 3. Install the fuel injection pump… Read More »
1. Lubricate the water pump O-ring with engine oil. 2. Install the engine coolant pipe gasket. 3. Install the water pump seal. 4. Install the water pump. Be sure the water pump studs align with the coolant tube. NOTE: Refer to Fastener Notice. 5. Install the water pump bolts. Tighten: Tighten the water pump bolts… Read More »