The Actuator Breakout Harness is used to measure the voltage supplied to the Injection Pressure Regulator (IPR). For electrical circuit diagnostics, install the breakout harness between the electrical harness and the valve. For Injection Control Pressure (ICP) system diagnostics, plug the Actuator Breakout Harness into the IPR valve only.
The 500 Ohm Resistor Harness is used for operational diagnostics of sensor circuits and Output State Tests for actuator control circuits.
The 12-Pin Breakout Harness is used for circuit diagnostics for the Injector Drive Module (IDM) powers and ground, actuator power and ground (EGR and VGT), in addition to some applications (IAT, service brake switch signals to the ECM, and ATA data link to and from the IDM).
The 4-Pin Injector Harness is used to measure continuity of the UVC wiring and injector solenoids.
The UVC Sensor Breakout Harness is used to access VREF, signal ground, and signal voltage circuits, after removing valve cover, for the following sensors: • Injection Control Pressure (ICP) • Brake Control Pressure (BCP)
The VC Gasket Breakout Harness is used to access VREF, signal ground, and signal voltage circuits, before removing valve cover, for the following sensors: • Injection Control Pressure (ICP) • Brake Control Pressure (BCP) The VC Gasket Breakout Harness is also used to check actuator ground and control for the brake shutoff valve circuit and… Read More »
The 3-Banana Plug Harness is used for operational diagnostics of sensor circuits.
The Breakout Harness Kit contains the following breakout harnesses and test leads: • 3-Banana Plug Harness (ZTSE4498) • VC Gasket Breakout Harness (ZTSE4658A) • UVC Sensor Breakout Harness (ZTSE4686) • 4-Pin Injector Harness (ZTSE4662) • 12-Pin Breakout Harness (ZTSE4665) • 500 Ohm Resistor Harness (ZTSE4497) • Actuator Breakout Harness (ZTSE4484) • APS/IVS Breakout Harness (ZTSE4485)… Read More »
The Breakout Box allows testing of the electronic control system components without disturbing connections or piercing wire insulation to access various signal voltages in the electronic control system. CAUTION: The Breakout Box is used for measurement only, not to activate or control circuits. High current levels passing through the breakout box will burn out the… Read More »
The Amp Clamp is to measure amperage draw for the glow plug and inlet air heater systems.