[1] – Park machine safely. [2] – Unplug connector from MBR switch. [3] – Attach ohmmeter leads across the switch terminals (A). [4] – Shift the PTO lever as directed and note meter readings. – Mid PTO and Mid+REAR PTO positions: no continuity – REAR PTO position: continuity [5] – If continuity is not correct,… Read More »
[1] – Park machine safely. [2] – Remove side panel to gain access to switch. [3] – Disconnect switch from wiring harness and remove switch from machine. [4] – →NOTE: Pins 10 and 18 are for the LED indicator light. Use ohmmeter to check continuity across switch terminals. a. If continuity is not present between… Read More »
[1] – Disconnect switch. [2] – Use ohmmeter to check continuity across switch terminals. a. If continuity is not present between terminals listed for each switch position, replace switch b. If continuity exists between terminals not listed for each switch position, replace switch.
[1] – Park machine safely. [2] – Remove left side engine panel to gain access to switch. [3] – Disconnect switch from wiring harness and remove switch from machine. [4] – Use ohmmeter to check continuity across switch terminals. a. If continuity is not present between terminals listed for each switch position, replace switch b.… Read More »
[1] – Disconnect switch. [2] – Use ohmmeter to check continuity across switch terminals. a. If continuity is not present between terminals listed for each switch position, replace switch b. If continuity exists between terminals not listed for each switch position, replace switch.
[1] – [2] – Remove center closeout panel. (See Remove and Install Center Closeout Panel in Section 90, Group 15.) [3] – Remove seat base. (See Remove Seat Base in Section 90, Group 15.) [4] – →NOTE: The top edge of the switch flange should be in line with the top edge of the bracket.… Read More »
[1] – [2] – Remove center closeout panel. (See Remove and Install Center Closeout Panel in Section 90, Group 15.) [3] – Disconnect wiring harness from reverse pedal switch. [4] – Use hydro pedals to move bell crank away from reverse pedal switch plunger. [5] – Use ohmmeter to check continuity across switch terminals. a.… Read More »
[1] – Park machine safely. [2] – Access the switch on the left side of the machine. [3] – Disconnect switch from wiring harness. [4] – Use ohmmeter to check continuity across switch terminals. a. If continuity is not present between terminals listed for each switch position, replace switch b. If continuity exists between terminals… Read More »
[1] – Disconnect switch. [2] – Use ohmmeter to check continuity across switch terminals. a. If continuity is not present between terminals listed for each switch position, replace switch. b. If continuity exists between terminals not listed for each switch position, replace switch.
[1] – Disconnect switch. [2] – Use ohmmeter to check continuity across switch terminals. a. If continuity is not present between terminals listed for each switch position, replace switch b. If continuity exists between terminals not listed for each switch position, replace switch.