1. Measure the resistance with ohmmeter across the a terminal and c terminal, and across the d terminal and e terminal. 2. If the measurement is not same as below, the hazard switch or the bulb are faulty.
1. Connect the battery negative code, then measure the voltage across the a terminal and chassis. 2. If the voltage differ from the battery voltage, the wiring harness is faulty.
1. Remove the meter panel and disconnect the 6P connector from hazard switch (1) after disconnect the battery negative code. 2. Remove the hazard switch (1). 3. Perform the following checking.
1. Disconnect the 8P connector (A) from the combination switch. 2. Set the turn signal switch to Left Turn position. 3. Measure the resistance with an ohmmeter across the B2 terminal to the L terminal. 4. If 0 ohm is not indicated, replace the combination switch.
1. Disconnect the 8P connector (A) from the combination switch. 2. Set the turn signal switch to Right Turn position. 3. Measure the resistance with an ohmmeter across the B2 terminal to the R terminal. 4. If 0 ohm is not indicated, replace the combination switch.
1. Disconnect the 8P connector (A) from the combination switch. 2. Set the light switch to LOW-BEAM position. 3. Measure the resistance with an ohmmeter across the B1 terminal to the T terminal and the B1 terminal to the 2 terminal. 4. If 0 ohm is not indicated, renew the… Read More »
1. Disconnect the 8P connector (A) from the combination switch. 2. Set the light switch to HI-BEAM position. 3. Measure the resistance with an ohmmeter across the B1 terminal to the T terminal and the B1 terminal to the 1 terminal. 4. If 0 ohm is not indicated, renew the… Read More »
1. Disconnect the 8P connector (A) from the combination switch. 2. Set the light switch to the OFF position. 3. Measure the resistance with an ohmmeter across the B1 terminal to the T terminal, the B1 terminal to the 1 terminal and the B1 terminal to the… Read More »
1. Disconnect the 8P connector (A) from the combination switch. 2. Measure the voltage with a voltmeter across the connector B1 terminal and chassis when the main switch is ON position. 3. If the voltage differs from the battery voltage, main switch or wiring harness is faulty. 4. Measure the voltage… Read More »
1. Remove the steering wheel and rear bonnet and disconnect 8P connector (2) after turning the main switch OFF position. 2. Perform the following checkings.