Remove capscrews (1) and (2), and install two 5/8 – 18 X 4-inch guide studs.
Warning: Because this part weighs more than 23 kg [50 lbs], two people or a hoist will be required to lift the flywheel housing to avoid personal injury. Remove the remaining capscrews and the flywheel housing.
NOTE: Use a mallet to loosen the housing from the dowels in the cylinder block if necessary.
Remove the guide studs.
On wet-type flywheel housings, remove the o-ring from the rear cover and the 11 rectangular sealing rings from the flywheel housing.
