1. Remove the brake rod and the propeller shaft.
2. Remove the hex. socket head plug from P1 or P2 port. (P2 is for forward and P1 is for reverse.)
3. Assemble long adaptor C (07916-60831) and threaded joint (07916-50341) with the gasket between them.
4. Install the assemble long adaptor C and threaded joint to P2 (forward) or P1 (reverse) port (thread size : Rc (PT) 1/4).
5. Install the cable, threaded joint in relief valve set pressure tester and high pressure gauge to threaded joint in order.
6. Check to see that parking brake is applied.
7. Run the engine at maximum speed.
8. Place the range gear shift lever in N position.
9. Depress the HST pedal, and measure the high pressure relief valve pressure.
10. If the measurement is not within the factory specification, check the high pressure relief valve assembly. (See page 3-S44.)
(When reassembling)
• Install the hex. socket head plug to the port with O-ring.
Condition
• Engine speed: Maximum
IMPORTANT
• Measure quickly so that the relief valve may not be in operation more than 10 seconds.
NOTE
• Be sure to use a pressure gauge with over 39.2 MPa (400 kgf/cm2, 5690 psi) capacity.
