1. Disengage the front wheel drive lever. (Drive only rear wheels.)
2. Set the cruise control to “OFF” position. (HST pedal is neutral position.)
3. Check to see that the length (A) of HST neutral rod (5) is specified length.
If not, adjust as follows
Length (A): 73.0 to 74.0 mm (2.88 to 2.91 in.).
4. Lift the rear of the tractor so that the rear wheels are off the ground and run the engine at maximum speed andย ย ย ย ย ย drive only rear wheels.
5. Slightly loosen the plate mounting screws (4).
6. Press the neutral holder arm (3) to the plate (1).
7. Then rotate the neutral holder (2) clockwise or counter clockwise until wheels stop completely.
8. Hold the neutral holder (2) and tighten the plate mounting screws (4).
NOTE
โข Be sure to tighten the plate mounting screw with specified torque.
