Different lubricating oil filters are available. Reference the appropriate Part Information resources when replacing the lubricating oil filter so that the correct lubricating oil filter can be installed on the engine being serviced.
If the dipstick tube option uses a pressed-in dipstick tube block insert: • Apply a thin bead of thread sealant around the bottom of the knurled end of the tube. • Place the knurled end of tube into the dipstick tube bore in the cylinder block. • Use the dipstick tube installer tool, Part Number… Read More »
If equipped with a locking dipstick, twist the handle counterclockwise to unlock. Pull up to remove the dipstick. Remove the dipstick from the dipstick tube. If equipped, remove any dipstick tube supports and clamps. If equipped, remove the flexible portion of the dipstick tube. If the dipstick option uses a pressed-in dipstick tube block insert:… Read More »
Due to the number of dipstick tube options, the following procedure has been generalized to cover common dipstick tube procedures. The illustrations may not match the engine being serviced.
NOTE: This procedure must begin with the lubricating oil pan drained. Drain the lubricating oil. Install the dipstick into the dipstick tube housing. Use clean lubricating engine oil to fill the oil pan to the specified “low” oil level. Refer to Procedure 018-017 in Section V. Remove the dipstick, and scribe a mark across the… Read More »
Be sure to remove the shipping plugs from the oil cooler element. When installing a new lubricating oil cooler be sure to use the correct part number. Replace with the same part number or use the engine serial number and QuickServ® to ensure the use of the correct part. Assemble the lubricating oil cooler cover,… Read More »
Use the lubricating oil cooler pressure test kit, Part Number 3823876, to pressure-test the element to check for leaks. If leaks are detected, replace the element.
Use solvent to clean the oil cooler housing and cover. NOTE: Replace the lubricating oil cooler if any debris is found or if the engine has had a debris-generating failure. Clean the sealing surfaces. When cleaning the oil cooler cover, be sure to clean the lubricating oil bypass valve. If any debris is suspected to… Read More »
Remove the lubricating oil cooler housing capscrews, housing, gaskets, and cooler element.
The lubricating oil cooler is mounted between the lubricating oil cooler cover and the cylinder block. Since neither the lubricating oil cooler or lubricating oil cooler cover can be removed without removing and installing the other, this procedure covers the removal and installation of both components.