If removed, install the oil suction tube. Refer to Procedure 007-035 in Section 7. For front gear train engines, apply a 2 mm [1116 in] bead of sealant, Part Number 3164067, to the oil pan mounting surfaces at the cylinder block to front gear housing joint and the cylinder block to rear crankshaft seal carrier… Read More »
NOTE: The use of air or power tools, such as a high speed sander with an abrasive pad, to clean the gasket material can overheat the oil pan and cause damage to the sealing flange. Clean the gasket surfaces. Remove all gasket material from the cylinder block and oil pan sealing surface. Steam clean the… Read More »
Oil Pan, Suspended NOTE: A suspended oil pan consists of the oil pan, mounting flange, and a flexible gasket. Remove the oil pan mounting capscrews, oil pan, mounting flange, and flexible gasket. NOTE: The lubricating oil pan flange can be damaged if a prybar or screwdriver is used to break the sealnt at the corners… Read More »
A front sump (1), rear sump (2), or center sump (3) lubricating oil pan can be used, depending on the application. The mounting of the lubricating oil pick-up tube will vary with the lubricating oil pan used.
Install a new a-ring in the groove on the underside of the filter head cover. Install a small a-ring in the groove on the other side of the filter head cover. Lubricate the a-rings with clean 15W-40 engine oil. Install a new a-ring in the groove of the center hose connector. Lubricate the a-rings with… Read More »
Use solvent to clean the parts. Dry with compressed air. Inspect the sealing surfaces for signs of leakage or burrs. Use a fine crocus cloth to remove burrs.
Make a mark on the lubricating oil filter head adapter and the lubricating oil cooler housing to align the filter head adapter during installation. Remove the lubricating oil filter head adapter by removing the center hose connection.
The following procedure is for engines with a remote mounted oil filter option. The mounting location of the oil filter will vary by application. Refer to the OEM service information for the location of the oil filter.
Use clean 15W-40 oil to coat the gasket surface of the filter. Fill the filter with clean 15W-40 oil. NOTE: Be careful that no debris is poured into the filter. If using an oil supply with a metallic or plastic seal under the cap, be careful to peel the seal back. Puncturing the seal with… Read More »
Clean the area around the lubricating oil filter head. Use the oil filter wrench, Part Number 3400158, to remove the filter. Clean the sealing surface of the filter head. NOTE: The oil filter sealing ring can stick on the oil filter head. Be sure that the sealing ring is removed.