[Inspection] • Press each belt at a central portion between pulleys with a force of approximately 98 N {10 kgf} as shown in the illustration and measure the amount of deflection of the belt. A: Cooler compressor pulley (for air conditioner) B: Tension pulley (for air conditioner) C: Crankshaft pulley D: Water pump pulley E:… Read More »
• The water pump has a drain hole to prevent coolant from entering the unit bearing in case of defect in the unit seal.
• The thermostat is a bottom bypass type that uses a wax-filled pellet as its flow-regulating element. When the wax is heated, it melts from solid to liquid, changing its total volume. This allows the valve to open or close in accordance with the coolant temperature, regulating and adjusting the flow of coolant to the… Read More »
#001 Inspection of combination switch AK14A connector connection table • For other inspections than shown above, see Gr54. • If there is any abnormality, replace the switch. (See Gr37.) #002 Inspection of starter switch AP2A, AN6A connector connection table • Terminal numbers within parentheses ( ) show terminals of AP2A. • If any fault is… Read More »
Removal sequence 1 Accelerator pedal (See later sections.) 2 Accelerator link (See later sections.) Installation sequence Follow the removal sequence in reverse. Removal procedure Removal: Accelerator pedal • Using pliers, pinch the hook of the stopper on the accelerator pedal. Separate the stopper from the pedal while turning the hook by about 15 degrees. Installation… Read More »
Removal procedure •Removal: Case – Loosen the water separator sensor and drain fuel from the case. – Remove the case using Installation procedure •Installation: Case Clean the O-ring mounting surface of the fuel filter head and the O-ring groove of the case. • Replace the filter element and O-ring with new one. • Apply a… Read More »