• Insert the air vent tube into fuel tank bracket, while taking care not to pinch or crush with the fuel tank band. Installation procedure •Installation: Fuel check valve Install the fuel check valve at the illustrated angle.
• Before removing the injectors, check injector mounting holes for trapped water and oil. • If any abnormality of the injector is found, replace it. Assembly sequence Follow the disassembly sequence in reverse. Installation procedure •Installation: Injection pipe – Ensure that the pipe and mounting surfaces of the connector are flat and free from damage.… Read More »
• If any abnormality of the common rail is found, replace it. Assembly sequence Follow the disassembly sequence in reverse. Removal procedure Removal: Injection pipe and fuel pipe Installation procedure •Installation: Injection pipe and fuel pipe – Ensure that the pipe and mounting surfaces of the connector are flat and free from damage. – Bring… Read More »
Installation: Supply pump • Remove the oil filler cap. • Bring the No. 1 cylinder piston to the top dead center (TDC) on the compression stroke according to the following procedure: • Rotate the crankshaft pulley in the direction of the arrow shown in the illustration until its notch aligns with the “0” scale mark… Read More »
• For servicing the supply pump assembly, contact a Bosch service station. Installation sequence Follow the removal sequence in reverse.
1. Inspecting and Adjusting No-load Minimum and Maximum Speeds [Work before inspection] • Before starting the inspection and adjustment, carry out the following preparatory steps: • Warm up the engine until the engine coolant temperature is approximately 80 to 95°C; (Check by Multi-Use Tester service data “13: Water temperature”.) • Turn off all lamps and… Read More »
• These inspections aid troubleshooting by enabling you to check whether electronic control unit signals are being correctly transmitted via the vehicle harness and connectors. The white-on-black numbers ( 01 , 02 , and so on) correspond to the similarly printed reference numbers in section “3. Inspections Based on Diagnosis Codes”. Electronic control unit connector… Read More »
• It is possible to see service data and actuator tests simultaneously.
• It is possible to see service data and actuator tests simultaneously.