[1] – Park machine safely. [2] – Rotate height of cut adjuster to lowest (install) position. [3] – Remove center closeout panel. (See Remove and Install Center Closeout Panel in Group 90, Section 15.) [4] – Remove four fasteners securing steering pedestal cowl. Remove cowl. [5] – Remove ten hex shoulder bolts securing foot rest.… Read More »
[1] – Park machine safely. [2] – Remove four fasteners (A) securing steering pedestal cowl. Remove cowl. [3] – Rotate height of cut adjuster control (B) to lowest (install) position. Remove control knob. [4] – Remove center closeout panel (C). (See Remove and Install Center Closeout Panel in Group 90, Section 15.) [5] – Remove… Read More »
[1] – Remove mid-mount mower deck, if installed. [2] – Park machine safely. [3] – Remove four fasteners (A) securing steering pedestal cowl. Remove cowl. [4] – Raise rockshaft to unload height of cut adjuster. [5] – Rotate height of cut adjustment control (B) to install position. [6] – Lower rockshaft to stop. [7] –… Read More »
→NOTE: Orient lift link eye bolts so that bend in yoke rod is facing front of machine. [1] – Install draft arm (A) to left side frame bracket. Secure draft arm with clevis pin (B) and locking clip (C). [2] – Thread lift link eye bolt midway into yoke (D). Install lift link assembly to… Read More »
[1] – Park machine safely. [2] – Remove mid-mount mower deck, if installed. [3] – Disconnect AutoConnect driveshaft coupler from transmission mid PTO shaft if machine is so equipped. [4] – Remove spring pins securing drilled pins (A). Support draft arms (B) and remove pins. Lower draft arms. [5] – Remove lift links (C) from… Read More »
[1] – Park machine safely. [2] – Raise hood. [3] – Remove spring locking clip and washer from bottom support pin (A). [4] – Hold up hood and remove pin. [5] – Remove bolts (B). [6] – Raise hood while pulling hood forward until hinge rods release from hinge, remove hood. [7] – Install hood:… Read More »
[1] – Park machine safely. [2] – Remove lock pin (A) and pivot pin securing center link (B) to rockshaft housing mast. Remove center link. [3] – Remove lock pin (C) and remove stabilizer from pivot pin. [4] – Rotate PTO shaft guard upward and remove lock pin (D) from pivot pin. Remove draft arm… Read More »
Adjust 3-point hitch links and stabilizers to position draft arms for most efficient attachment operation or to prevent excessive lateral movement. Stabilizers should be adjusted to position left and right draft arms the same distance from the machine centerline for PTO operation. [1] – Park machine safely. [2] – →NOTE: There are grooves in the… Read More »
[1] – Park machine safely. [2] – Loosen lug nuts before raising front axle. [3] – Raise rear of machine and lower onto support stands so that machine is supported by the rear axle. [4] – Remove wheel lug nuts and wheel. [5] – Install wheels in reverse order of removal. a. Install wheels onto… Read More »
[1] – Park machine safely. [2] – →NOTE: If wheels are being removed to perform work on the front axle, lower machine onto suitable stands so that machine is supported by the frame. Loosen lug nuts before raising front axle. [3] – Raise front of machine and lower onto support stands so that machine is… Read More »