[1] – Install the ROPS to the machine frame, aligning all mounting holes. [2] – Install two M12x35 hex bolts (A) through ROPS crossbar bracket, and loosely secure with hex nuts. [3] – Align flat on draft arm pivot pins (B) to ROPS mounting plate. Install pins through left and right ROPS mounting plates, machine… Read More »
The roll-over protective structure (ROPS) should only be removed as required for machine repair procedures. The ROPS must be reinstalled before the machine is put back into service. [1] – Remove three point hitch draft arms and support links. [2] – Cut tie wraps (A) securing ROPS wiring harness at bottom of left and right… Read More »
[1] – Install seat switch wire harness through openings in seat base. [2] – Align seat track mounting holes with front and rear mounting brackets. [3] – Install two hex socket bolts (A) and nuts securing seat tracks to front mounting bracket. Install socket head bolts far enough to allow seat to slide forward. [4]… Read More »
[1] – Remove center closeout panel. (See Remove and Install Center Closeout Panel in Section 90, Group 15.) [2] – Slide seat fully rearward, and remove two hex socket bolts (A) and nuts securing seat tracks to front mounting bracket. [3] – Slide seat base fully forward, and remove two hex socket bolts (B) and… Read More »
[1] – Position seat over seat base. [2] – Insert hinge pin (A) through mounting tabs on seat and base. [3] – Secure hinge pin with washer and locking pin (B). [4] – Install wire harness connector (C) to seat switch. [5] – IMPORTANT: Verify wiring harness is not damaged or hitting rockshaft casting. Make… Read More »
[1] – Park machine safely. [2] – Tip seat forward. Remove wire harness connector (A) from seat switch. [3] – Pass wire harness through openings in seat platform. [4] – Remove locking pin (B) and flat washer securing seat hinge pin. Remove hinge pin. [5] – Remove seat assembly.
[1] – Remove mid-mount mower deck, if installed. [2] – Park machine safely. [3] – Remove locking pins securing drilled pins (A). Support draft arms (B) and remove pins. Lower draft arms. [4] – Start engine, and raise rear rockshaft to highest position. Close rate of drop control to hold rockshaft in raised position. Shut… Read More »
[1] – Install and secure elbow fitting (A) to lift cylinder [2] – Push rod fully into cylinder. [3] – Remove hex nut and carriage bolt (B) securing fuel hose retainer. Move fuel hoses aside. [4] – Install hose support to footrest bracket and frame. Secure bracket with hex stop nut (C). Tighten nut to… Read More »
[1] – Remove mid-mount mower deck, if installed. [2] – Adjust height of cut control to install position, and fully lower mid mount rockshaft. [3] – Park machine safely. [4] – Remove four fasteners (A) securing steering pedestal cowl. Remove cowl. [5] – Rotate height of cut adjuster control (B) to lowest (install) position. Remove… Read More »
[1] – Park machine safely. [2] – Remove four fasteners (A) securing steering pedestal cowl. Remove cowl. [3] – Rotate height of cut adjuster control (B) to lowest (install) position. Remove control knob. [4] – Remove center closeout panel (C). (See Remove and Install Center Closeout Panel in Group 90, Section 15.) [5] – Remove… Read More »