Category Archives: L2501

1. Disconnect the 4P connector (1) and the 1P connector (2). 2. Remove the seat switch (3) from seat adjuster and disconnect the 3P connector (4). 3. Disconnect the 2P connectors (5).  

1. Remove the top link (1). 2. Remove the rubber spring (2), the lift rod (3) and the lower link (4).  

1. To open the bonnet, hold the bonnet with a hand and pull the release lever and open the bonnet. 2. Disconnect the battery negative cable (1). 3. Install the front axle rocking restrictor (2) (refer to “SPECIAL TOOLS” (see page G-55)) to the front axle bracket and chock the wheels.  

1. Remove the drain plugs (1) at the bottom of the transmission case and drain the oil completely into the oil pan. 2. After draining reinstall the drain plugs. (When reassembling) • Fill up new oil to the upper line of the gauge (2) from the oil inlet port after removing the oil inlet plug… Read More »

1. Place the disassembling stand under the transmission case. 2. Remove the mid case and transmission case mounting nuts. 3. Separate the mid case and transmission case. (When reassembling) • Apply liquid gasket (Three Bond 1206C or equivalent) to the joint faces of mid case and transmission case.  

1. Remove the return pipe (1) and the delivery pipe (2). 2. Remove the damper (3). 3. Disconnect the brake rod (4) and the range shift rod (5). (When reassembling) • Install the new copper washers securely.  

1. Place the disassembling stand under the mid case. 2. Remove the clutch housing and mid case mounting screws. 3. Separate the clutch housing cae. (When reassembling) • Apply liquid gasket (Three Bond 1206C or equivalent) to the joint faces of clutch housing case and mid case.  

1. Remove the front step bracket (R.H.) (1) and filter bracket stay (2). 2. Disconnect the suction pipe (3), the delivery pipe (4). 3. Disconnect the clutch rod (6) and the HST pedal rod (5). (When reassembling) • Be sure to adjust the HST neutral position. (See page 3-S12.)  

1. Disconnect the wirings (1) for fuel sensor. 2. Disconnect the 4P connector (2), the 4P connector (3), the 6P connector (4) and the 4P connector (5). 3. Disconnect the HST pedal switch 4P connector and remove the slow blow fuse box (6). 4. Disconnect the 2P connector (7) and the ground cables (8). 5.… Read More »

1. Disconnect the wiring (1). 2. Disconnect the wirings (2). 3. Disconnect the 1P connector (3), (7) and the wirings (5), (6). 4. Remove the shutter plate (4) and the wirings from the engine.