1. Remove the grip (1). 2. Remove the position control lever grip and position control lever guide (2). 3. Remove the floor sheet cover (3). 4. Remove the neutral holder cover (4) and the center cover (5). 5. Disconnect the brake pedal spring. 6. Remove the HST control pedal (6) and step (R.H.) (7). 7.… Read More »
1. Remove the steering wheel (1) with steering puller and the rubber steering cover (10). 2. Remove the throttle grip (2). 3. Remove the rear bonnet (3). 4. Disconnect the 4P connector (5), the 8P connector (6), the 6P connector (7) and the 20P connector (8). 5. Disconnect the hour-meter cable and remove the meter… Read More »
1. To open the bonnet (1), hold the bonnet with a hand and pull the release lever and open the bonnet. 2. Disconnect the battery negative cable. 3. Disconnect the head light connector (3). 4. Remove the snap pin (4) and disconnect the bonnet damper (5) from the bonnet. 5. Remove the screws (6). 6.… Read More »
1. Remove the drain plugs (1) at the bottom of the transmission case and drain the oil completely into the oil pan. 2. After draining reinstall the drain plugs. (When reassembling) • Fill up new oil to the upper line of the gauge (2) from the oil inlet port after removing the oil inlet plug… Read More »
1. Place the disassembling stand under the clutch housing case. 2. Remove the clutch housing and mid case mounting screws. 3. Separate the clutch housing and mid case. (When reassembling) • Apply liquid gasket (Three Bond 1206C or equivalent) to the joint faces of clutch housing and mid case.
1. Remove the suction pipe (1) and the filter bracket stay (2). 2. Disconnect the spring (3) and remove the neutral hold arm (4). 3. Disconnect the HST pedal rod (5) and the clutch rod (6). 4. Remove the steering support (7). (When reassembling)
1. Disconnect the 4P connector (1), the 2P connector (2) and the ground cable. 2. Remove the slow blow fuses (3), clips (4) and wire from the steering support.
1. Check the clutch housing case and transmission case are securely mounted on the disassembling stands. 2. Loosen and remove the transmission case mounting nut. 3. Separate the transmission case from the clutch housing case. (When reassembling) • Apply liquid gasket (Three Bond 1206C or equivalent) to joint faces of transmission case and clutch housing… Read More »
1. Remove the front wheel drive case (1) and lever (2). (When reassembling) • Be sure to assemble the gasket. • If gasket is damaged, replace it.
1. Remove the screw (4) then tap out the spring pin (3). 2. Slide the propeller shaft cover 1 (5) to the front and the cover 2 (6) to the rear. 3. Tap out the spring pins (1) and then slide the coupling (2) to the front and coupling (8) to the rear. (When reassembling)… Read More »