1. Insert the clutch center tool. 2. Remove the clutch assembly together with the clutch center tool. (When reassembling) • Direct the shorter end of the clutch disc boss toward the flywheel. • Apply molybdenum disulfide (Three Bond 1901 or equivalent) to the splines of clutch disc boss. • Insert the pressure plate, noting the… Read More »
1. Check the engine and clutch housing case are securely mounted on the disassembling stands. 2. Remove the engine mounting screws, and separate the clutch housing case from the engine. (When reassembling) • Apply grease to the splines. • Apply liquid gasket (Three Bond 1206C or equivalent) to joint face of the engine and clutch… Read More »
1. Remove the screw (4) then tap out the spring pin (3). 2. Slide the propeller shaft cover 1 (5) to the front and the cover 2 (6) to the rear. 3. Tap out the spring pins (1) and then slide the coupling (2) to the front and coupling (8) to the rear. (When reassembling)… Read More »
1. Disconnect the HST delivery pipe (1) from power steering controller. 2. Remove the step bracket assembly (2). 3. Remove the clamp (3) and the HST delivery pipe (1). 4. Remove the eye joint screw (5) and the HST return pipe (4). (When reassembling) • When reassembling the HST return pipe, install the new copper… Read More »
1. Disconnect the suction hose (1). 2. Remove the delivery pipe (2). (When reassembling) • When reassembling the delivery pipe, install the new copper washers securely.
1. Remove the grip (1). 2. Remove the position control lever grip and position control lever guide (2). 3. Remove the floor sheet cover (3). 4. Remove the neutral holder cover (4) and the center cover (5). 5. Disconnect the brake pedal spring. 6. Remove the HST control pedal (6) and step (R.H.) (7). 7.… Read More »
1. Disconnect the reserve tank hose and remove the reserve tank (1). 2. Remove the battery (2) and the screws (3) from the battery support (4). 3. Disconnect the hoses (5) from the oil cooler (6). 4. Remove the battery support assembly (7).
1. Remove the screw from support (1) and the steering joint shaft (2). 2. Remove the accelerator rod (3). (When reassembling) • Lift the universal joint so that there should be a clearance (A) of more than 5 mm (0.2 in.) between the universal joint and flywheel housing. Then fit the support… Read More »
1. Disconnect the wiring (1). 2. Disconnect the 4P connector (3), the starter relay (2), the engine stop solenoid relay (5) and the flasher unit (4). 3. Remove the wiring from the rear bonnet support. 4. Remove the meter panel support (6) from rear bonnet support.
1. Disconnect the wiring (1). 2. Disconnect the wirings (2). 3. Disconnect the 1P connector (3), (7) and the wirings (5), (6). 4. Remove the shutter plate (4) and the wirings from the engine.